How to Replace an iPM100 Generator
Replacing the iPM100 generator in your Vetaphone system is a straightforward process that can be accomplished with a few simple steps. For a visual demonstration, please refer to the video below. Follow these steps to ensure a smooth replacement:
Step 1: Safety First
Before you begin, make sure to turn off and unplug the Vetaphone system. This is crucial to prevent any electrical hazards during the replacement process. Additionally, allow the system to cool down if it has been in operation.
Step 2: Gather Necessary Tools
You will need a few basic tools for the replacement, including a screwdriver, a wrench, and a allen key set. Having these tools ready will help streamline the process.
Step 3: Access the Generator
Locate the iCorona cabinet. Use your cabinet key to open the iCorona door. Once opened, you will have direct access to the iPM100 generator.
Step 4: Disconnect the Old Generator
Carefully disconnect the wiring harness from the old iPM100 generator. It’s important to take note of how the wires are connected, as you will need to replicate this setup with the new generator. If necessary, take a photo for reference.
Step 5: Remove the Old Generator
Using your Allen Key, unscrew the bolts holding the old generator in place. Once loose, gently lift it out of the compartment. Be cautious not to damage any surrounding components during this process.
Step 6: Install the New Generator
Position the new iPM100 generator in the same location as the old one. Secure it with the bolts you previously removed. Ensure it is tightly fastened to avoid any vibrations during operation.
Step 7: Reconnect the Wiring
Reconnect the wiring harness to the new generator, following the reference photo you took earlier. Make sure all connections are secure to ensure proper functionality.
Step 8: Close the Access Panel
Once everything is connected, replace the access panel and secure it with the screws you removed earlier.
Step 9: Power Up the System
Plug the Vetaphone system back in and turn it on. Monitor the system for a few minutes to ensure the new generator is functioning correctly.
By following these steps, you can successfully replace the iPM100 generator in your Vetaphone system. If you encounter any issues or have further questions, please don’t hesitate to reach out to our customer support team for assistance. You can also see the video below that shows you the process.